Rabbit Interleukin 1 (IL-1) Quantitative Detection Kit (ELISA)
user's Guide
[Rabbit Interleukin 1 (IL-1) Elisa Kit Kit Name]
Rabbit Interleukin 1 (IL-1) Quantitative Detection Kit (ELISA)
[Rabbit Interleukin 1 (IL-1) Elisa Kit Kit Usage]
Quantitative detection of interleukin 1 (IL-1) in rabbit serum, plasma and related liquid samples.
[Rabbit Interleukin 1 (IL-1) Elisa kit detection principle]
This kit uses double-antibody two-step sandwich enzyme-linked immunosorbent assay (ELISA). Add the standard and the test sample to the pre-coated rabbit interleukin 1 (IL-1) monoclonal antibody transparent enzyme label coated plate. After incubation for a sufficient time, wash to remove unbound components, and then add the enzyme label After incubating the working solution for a sufficient period of time, wash to remove unbound components. Substrates A and B are added in sequence, and the substrate (TMB) is converted into a blue product catalyzed by horseradish peroxidase (HRP), which turns yellow under the action of an acid. The concentration of 1 (IL-1) is positively correlated. The OD value is measured at a wavelength of 450 nm. Based on the OD value of the standard and the sample, calculate the content of rabbit interleukin 1 (IL-1) in the sample.
[Rabbit Interleukin 1 (IL-1) Elisa Kit Kit Composition]
1
Enzyme coated plate
12 holes × 8
7
Developer A liquid
6mL
2
Standard
0.3mL × 6 tubes
8
Developer B liquid
6mL
3
20 times concentrated washing liquid
25mL
9
Stop solution
6mL
4
Sample diluent
6mL
10
Instructions
1 serving
5
Special diluent
6mL
11
Sealing film
2 sheets
6
Enzyme reagent
6mL
12
sealed bag
1
Remarks: The concentration of standard products (No. 1 → No. 6) is: 320, 160, 80, 40, 20, 10ng / L.
[Rabbit Interleukin 1 (IL-1) Elisa kit required but not provided reagents and equipment]
1. 37 ℃ thermostat
2. Standard specification microplate reader
3. Precision pipettes and disposable tips
4. Distilled water
5. Disposable test tubes
6. Absorbent paper
[Rabbit Interleukin 1 (IL-1) Elisa kit operating steps]
1. Preparation: Remove the reagent kit from the refrigerator and re-equilibrate at room temperature for 30 minutes.
2. Mixing solution: dilute the 20-fold concentrated washing solution with distilled water to the original one.
3. Add standard products and samples to be tested: take a sufficient number of enzyme-coated plates and fix them to the frame. Set up standard wells, sample wells to be tested and blank control wells, record the positions of each well in the standard wells. Add 50μL of standard product; first add 10μL of sample to be tested, and then add 40μL of sample diluent (that is, the sample is diluted 5 times); blank control well is not added.
4. Incubation: Incubate in a 37 ° C water bath or thermostat for 30 minutes.
5. Wash the plate: discard the liquid, pat dry on the absorbent paper, fill each hole with the washing solution, let stand for 1min, shake off the washing solution, pat dry on the absorbent paper, repeat the washing 4 times (you can also use the washing machine to press Instructions for washing the board).
6. Add enzyme-labeled working solution: add 50μL of enzyme-labeled working solution to each well, without adding blank control wells.
7. Incubation: Incubate in a 37 ° C water bath or thermostat for 30 minutes.
8. Wash the plate: discard the liquid, pat dry on the absorbent paper, fill each hole with washing liquid, let stand for 1min, shake off the washing liquid, pat dry on the absorbent paper, repeat the plate washing 4 times (you can also use the washing machine to press Instructions for washing the board).
9. Color development: add 50μL of developer A solution to each well, and then add 50μL of developer B solution, mix for 30s with a plate mixer (or gently shake for 30s by hand), and avoid color development at 37 ℃ for 15min .
10. Termination: Remove the enzyme labeling plate and add 50μL of stop solution to each well to stop the reaction (the color changes from blue to yellow).
11. Determination: Zero the blank holes, and within 15 minutes after termination, measure the absorbance (OD value) of each well with a wavelength of 450 nm.
12. Calculation: According to the concentration of the standard product and the corresponding OD value, calculate the linear regression equation of the standard curve, and then calculate the corresponding sample concentration on the regression equation according to the OD value of the sample. You can also use various application software to Calculation. The final concentration is the actual measured concentration times the dilution factor.
[Rabbit Interleukin 1 (IL-1) Elisa kit sample requirements]
1. The sample cannot contain sodium azide (NaN3) because sodium azide (NaN3) is an inhibitor of horseradish peroxidase (HRP).
2. The specimen should be extracted as soon as possible after collection. The extraction should be carried out according to relevant literature. The experiment should be carried out as soon as possible after extraction. If the test cannot be performed immediately, the specimen can be stored at -20 ℃, but repeated freezing and thawing should be avoided.
3. The sample should be fully centrifuged, without hemolysis and particles.
[Rabbit Interleukin 1 (IL-1) Elisa kit notes]
1. The experiment is carried out in strict accordance with the instructions, and the result of the experiment must be determined by the reading of the microplate reader.
2. If the enzyme-labeled coated board is not used up after opening, it should be put into a sealed bag and added with desiccant immediately.
3. It is recommended that all standards, samples and blank controls be tested in duplicate, and the average value is taken to reduce the experimental error.
4. Keep in mind that the sample has been diluted 5 times. The calculation result is multiplied by 5 to obtain the actual concentration of the sample.
5. The quantitative range of this kit is 10-320ng / L. If it exceeds this range, it is calculated by the extension of the standard curve. It is not used as an accurate quantitative result. ), Multiplied by the total dilution factor is the final concentration of the sample.
6. If the color is too light, the substrate incubation time can be extended properly.
7. In order to avoid cross-contamination, the tips, samples and blank controls should be replaced with a new one for each addition; the common components such as enzyme working solution, sample diluent and substrate should be cantilevered, and they should not touch the microwells. ; Do not reuse the sealing film.
8. The kits are used within the warranty period, and different batches of reagents should not be mixed.
9. Substrate B is sensitive to light and avoid prolonged exposure to light.
[Rabbit Interleukin 1 (IL-1) Elisa kit operating procedures summary]
Prepare reagents, samples and standards
Add prepared samples and standards, and react at 37 ℃ for 30 minutes
Wash the plate 4 times, add the enzyme reagent, and react at 37 ℃ for 30 minutes
Wash the plate 4 times, add color developing solutions A and B, and develop at 37 ℃ for 15 minutes
Add stop solution
Read OD value within 15 minutes
Calculation
[Rabbit Interleukin 1 (IL-1) Elisa kit detection range]
10ng / L – 320ng / L
[Rabbit Interleukin 1 (IL-1) Elisa Kit Specifications]
96 servings / box
[Storage of Rabbit Interleukin 1 (IL-1) Elisa Kit]
Store at 2-8 ℃, protected from light and moisture.
[Rabbit Interleukin 1 (IL-1) Elisa kit expiry date]
6 months
Non Woven Bag Tote Bags can make a good substitute for carrying groceries and the shopping. You can keep the bag with the cashier, and then put your purchases into it instead of the usual plastic bag.
Recycling the bags you already have is another good idea. These can come into use for various purposes, like holding your garbage, instead of purchasing new ones.
While governments may be working out ways to lessen the impact of Plastic Bags on the environment; however, each of us should shoulder some of the responsibility for this problem, which ultimately harms us. Plastics are not only non-biodegradable, but are one of the major pollutants of the sea. For a clean and green environment, try to use alternatives to plastic whenever and wherever possible. Cut down your use of plastic, and do your bit to save our planet.
Our company focus on Custom Eco Friendly Non Woven Bag Tote. We allow you to make a choice from a wide range of products in bags that come in all sizes, and these can be used repeatedly and last for years if taken care of. Upload the Non Woven Grocery Bag artwork you wish to have printed on your Eco Non Woven Bags wholesale order and let us do the rest. You can choose some smart color options, sizes, and shapes of bags to suit your store. Have a look at some examples of past orders for Recycled Bags Wholesale we have made to spark some ideas of your own to help your brand goes more popular.
Non Woven Bag Tote, is more and more popular in nowadays, most of reports show PP Non Woven Bags that look like a cross between paper and cloth and are now being used widely as a replacement for plastic bags, especially widely used for shopping tote bag, reusable grocery bags.
Non Woven Grocery Bag are white trash instead of new products, with the increase of new energy sources, the government to promote green energy, and increasingly serious environmental pollution, in order to get rid of this white pollution, make our lives better, many environmentally conscious people think of a new product - woven bags, and its advantages are obvious.
Why choose us ?
We are professional china manufacture of shopping Eco Non Woven Bags & packaging Reusable Grocery Bags, with more than 10 years production experience.
Our plant located in Wenzhou city, zhejiang which have industry chain advantage, such as material, printing , packing and so on.
All our Non Woven Bag Tote are supported by ALIBABA Trade assurance. No need to concern the business will not completed in time.
Our PP Non Woven Bags are complied with EU stand,total Eco-friendly to the world.
We have professional inspection worker and engineer to check the goods 100%, but also we have specialized after- sales department to solve your problem as soon as possible
Our company is customer-centered and much attention has been paid to personnel. With elaborate management, we aim to achieve sustainable development and become a clear-conscience company. We'll provide you the best quality Shopping Tote Bag and Eco Non Woven Bags with competitive price.
PP Non Woven Bags
Non Woven Bag Tote,Non Woven Grocery Bag,Foldaway Non Woven Bags,Eco Non Woven Bags
WenZhou JinYuan Packing Manufacture Co.,Ltd , https://www.tote-shoppingbag.com