The water tower is in one of the internal configurations of the thermal shock test chamber and is an important part of the entire operation. The components that need to be used in both the temperature and the operating wind speed. In this case, if there is a fault, how to eliminate the problem and find the cause. In the following, I will talk about the solution for everyone.
When the temperature of the cooling water in the thermal shock test chamber rises, the air volume is uneven. When the air is circulated again, when the heat sink blocks the water spray pipe, the best way is to improve the ventilation environment and then eliminate the heat dissipation. Material blocking area, removal of dirt and algae. If the fan is not properly installed during noise and vibration, the fan needs to be reinstalled. When the water droplets are excessively splashed, the water spray pipe will rotate too fast, and the heat dissipation material will be blocked. If the water stop device fails, the angle of the water spray pipe should be adjusted to eliminate the blockage of the heat dissipation material, and then the water retaining device should be replaced. Device. When the motor is overloaded, the voltage may drop too low, check the power supply and adjust.
The test work caused by the failure of the water tower has a great influence, so the integrity of the components used in each step and the problem are minimized before the test. This makes the test results most reliable and accurate.
Ss Wok,Large Stainless Steel Wok,Stainless Steel Induction Wok,304 Stainless Steel Wok Non Stick
SUZHOU JIAYI KITCHENWARE TECHNOLOGY CO.,LTD , https://www.jiayi-kitchenwares.com