How to properly choose the right drop test machine

About drop test machine

The drop test machine is specially designed to test the product packaging or parts, the damage situation when they are dropped, and to evaluate the impact resistance of the electronic components when they are dropped. In some manufacturers that produce toys, electronics, electrical appliances, communications, IT, furniture, gifts, ceramics, packaging, etc., the finished products or components are tested for drop.

Choose a drop test machine tutorial

In terms of working principle, the drop test machine can be divided into three categories

1. A good drop test machine can make accurate judgments in the case of impact strength or damage when dropped when it falls naked (without packaging) or when packaging falls (finished product and outer packaging are dropped together).

1. The drop height range is generally around 300-1500mm

2. The height setting range is light rain or equal to 2% of the set value

3. The maximum load should reach 100 kg

4. The error of the drop angle is light rain or equal to 5 °

5. Motor power 1 / 2HP

2. Choose the zero-drop test for packages (dropping at lower heights of diamond, surface, and cross). The drop height starts from zero. In the direction of double-column road, hydraulic buffer, drop height can be set.

1. The drop height is generally 0 to 1000mm or higher

2. The maximum load is 200 kg

3. The maximum size of the test piece is about 1000mm

3. Drop test on large furniture, desks, chairs, and other test pieces. Specifications can be customized. Selection features: digital display height, electric lift, electric double arm synchronization / reset. The distance between the two columns is adjustable, and it can also be used for single arm drop.

1. The drop height range is generally 400mm to 1500mm

2. The allowable range of the test piece is (length * width * height) 3000mm * 2000mm * 1500mm

3. The maximum load is 300 kg

The use standard of drop test machine

1. After each test is completed, the drop arm needs to be dropped to prevent the long-reset drop arm from pulling the spring and deforming it, which affects the test effect. Each time you drop the money, please reset the position and stop the motor before pressing the drop button.

2. After the new machine is installed at the factory, it is necessary to add low-concentration engine oil to the sliding round bar. It is strictly prohibited to add anti-rust oil or high-concentration engine oil and corrosive oil with backlog.

3. If there is too much dust in the oiling place for a long time, please lower the machine to the bottom, wipe the previous engine oil and re-oil.

4. The drop machine is an impact mechanical device. When the new machine is used more than 500 times, it is necessary to tighten a screw to avoid failure.

5. The lifting shaft and chain of the testing machine need to be lubricated regularly.

6. The gear reducer changes oil transmission every six months.

7. Please test at a room with low humidity (no condensation below 80%) and a place with little dust and dust.

8. In order to prevent the machine from losing control during the operation and cause accidents and electric shock, please be sure to turn off the power before performing the operation. Keep the lifting shaft clean.

9. Non-operating personnel shall not operate the machine arbitrarily.

Triple Rotors Watch Winder, suitable for both man and women. Our products are all made of wood and exquisite workmanship. Double automatic watch winder can rotates clockwise, counter-clockwise or alternate it will work with all kind of automatic watches. his automatic watch winder will keep your automatic timepieces wound and ready to wear when you need them. This product also can wind up three automatic watches, or more than three, and this watch winder with Japanese mabuchi rotor, it's very quiet. It would not  disturb your sweet dream even you put it in your bedroom. This product has high quality, high sales volume and low price in our company.

Triple Rotors Watch Winder

Triple Rotors, watch winder with storage, multi-rotors watch winder

GUANGZHOU T.WING-PAK MFG.CO.,LTD , https://www.watch-winder-factory.com