Flat design commonly used manufacturing size list (below)

Three-fold advertising:
Standard size: (A4)210mm x 285mm

Ordinary brochures:
Standard size: (A4)210mm x 285mm

Document envelope:
Standard size: 220mm x 305mm

Posters:
Standard size: 540mm x 380mm

Banners:
Standard size: 8 open 376mm x 265mm

4 open 540mm x 380mm

Handbag:
Standard size: 400mm x 285mm x 80mm

Letters, notes:
Standard size: 185mm x 260mm 210mm x 285mm
Flat design commonly used manufacturing size list
June 19, 2006 14:24 Source: 52print

Plane design commonly used to create a size list of positive paper:
787×1092 mm
Opening number (positive) Size unit (mm)
Full open 781×1086
2 open 530×760 3 open 362×781
4 open 390×543 6 open 362×390
8 open 271×390
16 open 195×271
Note: Finished Size = Paper Size - Trimming Size

Large paper:
850×1168 mm
Opening number (positive) Size unit (mm)
Full open 844×1162
2 open 581×844 3 open 387×844
4 open 422×581 6 open 387×422
8 open 290×422
Note: Finished Size = Paper Size - Trimming Size

Common opening size:
787 x 1092 mm
Opening number Size unit (mm)
Off: 736 x 520
4 open: 520 x 368
8 on: 368 x 260
16-on: 260 x 184
32 on: 184 x 130

Open size (large):
850 x 1168mm
Open size unit (mm)
Off: 570 x 840
4 on: 420 x 570
8 open: 285 x 420
16 on: 210 x 285
32 open: 203 x 140

Positive paper:
787×1092mm
Opening number Size unit (mm)
Full open 781×1086
2 open 530×760
3 open 362×781
4 open 390×543
6 open 362×390
8 open 271×390
16 open 195×271
Note: Finished Size = Paper Size - Trimming Size

Bigness × Paper:
8501168mm
Opening number (positive) Size unit (mm)
Full open 844×1162
2 open 581×844
3 open 387×844
4 open 422×581
6 open 387×422
8 open 290×422
Note: Finished Size = Paper Size - Trimming Size

16 degrees of openness: 210×285 Positive degrees: 185×260
8 Openness: 285×420 Positive: 260×370
4 Openness: 420×570 Positive: 370×540
2 Openness: 570×840 Positive: 540×740
Full size: 889×1194 Small: 787×1092

business card:
Horizontal version: 90*55mm<Square angle> 85*54mm<Fillet>
Vertical version: 50*90mm<square angle> 54*85mm<rounded corner>
Square Edition: 90*90mm 90*95mm

IC card:
85x54MM


Three-fold advertising:
Standard size: (A4)210mm x 285mm

Ordinary brochures:
Standard size: (A4)210mm x 285mm

Document envelope:
Standard size: 220mm x 305mm

Posters:
Standard size: 540mm x 380mm

Banners:
Standard size: 8 open 376mm x 265mm

4 open 540mm x 380mm

Handbag:
Standard size: 400mm x 285mm x 80mm

Letters, notes:
Standard size: 185mm x 260mm 210mm x 285mm


Source: 52print

Manual burr grinders are turned by hand, rotating one grinding surface against the other. Coffee mills usually have a handle, providing leverage for the many turns required to grind enough coffee for a cup. The ground coffee is collected in a container which is part of the mill.

Salt, pepper, and spice mills, essentially the same as coffee mills, usually do not have a handle, the entire top rotating instead. While this is less convenient, only a few turns are required to grind enough. The ground product falls directly onto the food being seasoned; the mill has no container. A few designs have abrasive surfaces which do not rotate; each squeeze of the handles moves one flat plate past another, then the plates are restored to their original position by a spring. Many hard spices are available in containers incorporating a simple cone burr grinder, intended to be discarded when empty.

Most grinders can be adjusted to set the fineness of grind.

Manual mills can be used for grinding other food products than they are intended for, but mills designed for pepper grinding are inappropriate for producing finely-ground flour. Laura Ingalls Wilder's novel The Long Winter describes a family grinding wheat in a coffee mill to make flour during months of hardship.

The first Coffee Grinder was made by Richard Dearmann, an English blacksmith from Birmingham, in 1799. Then this grinder was widely distributed in the US, where Increase Wilson patented the first wall coffee grinder in 1818.[citation needed]

Peugeot of France patented a Pepper Grinder in 1842. The mechanism of case-hardened steel cracked the peppercorns before the actual grinding process. The grooves on the Peugeot mechanism were individually cut into the metal and then case-hardened, making them very durable.[citation needed]

Pepper and Salt Mill

Pepper Mill, Salt Mill, Pepper Grinder, Plastic Kitchen Gadget, Kitchen Gadget

HOMEARTS INDUSTRIAL CO.,LTD , http://www.homeartschina.com